Legit Video Card Reviews
NVIDIA GeForce GTX 680 2-Way SLI Video Card Review
|Product:||EVGA GeForce GTX 680|
|Date:||Thu, Apr 05, 2012 - 12:00 AM|
|Written By:||Nathan Kirsch -|
Temperature & Noise Testing
Since video card temperatures and the heat generated by next-generation cards have become an area of concern among enthusiasts and gamers, we want to take a closer look at how the graphics cards do at idle, during gaming and finally under a full load.
Temperatures signifcanlty increase when running SLI due to the airflow around the cards and the inside card usually always runs hotter since it is stuck between the other card and the processor area. The inner card idled at 47C and the outer card at 40C on our open air test bench. Notice that the fan speeds were different due to the different temperatures of the cards. The inner card was running at 1200RPM, while the outside card was running at 1000RPM. Running SLI does make for a hotter and louder system!
When running Furmark with the GeForce GTX 680's in SLI we saw the cards reach 82C and 86C, respectively. Both cards were at 98% GPU load, but notice the fan speed difference again. One is running 2940 RPM and the other is running 2400 RPM. This 540 RPM difference is due to the 4C temperature difference on the cores as that is how the fan profiles are programmed.
After Furmark was turned off you can see that the cards temperatures recovered quickly.
Using the peak temperature from GeForce GTX 680 SLI setup you can see that it does run hotter than a single card. We were running 12C warmer at idle, but only 5C hotter at full load in gaming and Furmark.
We recently upgraded our sound meter to an Extech sound level meter with ±1.5dB accuracy that meets Type 2 standards. This meter ranges from 35dB to 90dB on the low measurement range, which is perfect for us as our test room usually averages around 38dB. We measure the sound level two inches above the corner of the motherboard with 'A' frequency weighting. The microphone wind cover is used to make sure no wind is blowing across the microphone, which would seriously throw off the data.
The NVIDIA GeForce GTX 680 SLI setup put out more heat and as a result the fans had to run faster to keep up. We found a 2.8dBA increase in noise at idle and during gaming it jumped up to being a 5.6dBA increase. As you can see you get increased noise and temperatures with SLI, but you likely already knew that.
Next Page - Final Thoughts and Conclusions
Page 1 - NVIDIA GeForce GTX 680 in 2-Way SLI
Page 2 - Test Setup
Page 3 - Batman: Arkham City
Page 4 - Battlefield 3
Page 5 - Deus Ex: Human Revolution
Page 6 - DiRT 3
Page 7 - H.A.W.X. 2
Page 8 - Just Cause 2
Page 9 - Metro 2033
Page 10 - 3DMark 11
Page 11 - Unigine Heaven 3.0
Page 12 - Power Consumption
Page 13 - Temperature & Noise Testing
Page 14 - Final Thoughts and Conclusions