Legit Case Reviews
ThermalRock Circle Full Tower Case
|Product:||Circle Full Tower Case|
|Date:||Tue, May 10, 2005 - 12:00 AM|
|Written By:||Yves Toleno -|
Inside the case there is a box that contains drive rails, a manual and 4 red CD-R’s for the front of the case. There are three styles of drive rails, 6 CD-ROM, 5 Hard Drive and 2 Floppy Drive rails. The box also includes a key for locking the case door. I decided to test fit my case with my home theater and I must say it looked good and like it belonged. The styling did not match what I already have on the plus side it does not look like a computer case either.
I swapped out the purple CD-R’s for the red ones because I find that they look better, though that’s my taste. Opening up the case door you can see the five exposed 5.25” drives and the two 3.5” bays. Also visible is the front grill which actual allows for some air flow. The front door to the ThermalRock Circle is raised off the front bezel allowing for air to come in from the top and bottom as well as a gap in the bezel it’s self.
Sadly the cool looking arm on the front of the case is not able to read CD’s but who knows it could happen in the future?. With the front door open there are two thumb screws that hold the arm in place loosening the screws allows you to adjust it from the top position to the bottom position.
Spinning the black disks on the back of the door reveals the CD holder. Not much really to say about this because I don’t think it’s all that functional more of an eye candy thing really. It is a decent design and I had no problem loading in the red disks and screwing back on the black covers.
On the top of the case are two USB ports and a firewire port. I am very glad that ThermalRock put them on the outside of the case rather than behind the door as this makes them far more functional. In the bottom left corner of the front bezel are the headphone and microphone jacks. This time around I am not thrilled with the placement. This case is large and heavy so there is almost no chance that it will ever be on a desk where the ports are actually accessible.
The back of the case is simple and has a spot for the power supply at the top
with a large 120mm fan grill on the exhaust. The only thing of real note is
the side panel locking system. Four plastic latches held down with screws snap
into place locking or unlocking the side panels. While neat in concept I did
not find the latches to work all that well, luckily they do not detract from
the overall functionality or design of the case.
Inside the case you can see how much room there really is to work with. Up to six hard drives can be mounted vertically below the power supply allowing for the heat to be drawn up and out the back. You can also see that the motherboard is mounted upside down allowing for the two 120mm fans to create decent air flow over the cpu and heatsink.
Here is a simple close up of the hard drive mounting cage and the extra 80mm fan slot that could help cool the graphics cards and create some air flow above the cpu region.
Here are the two fans that cool the system. They are very quiet I really don’t
notice them, but then in my room anything under 45dB is quiet. The fans are
powered with two 4pin Molex connectors and have a separate tachometer wire that
connects to the motherboard.
The last thing were going to look at before I start installing they system is the tool-less PCI slots. The black clamps snap up allowing you to insert the PCI card and then snap closed pushing down on the PCI cards tab holding it firmly in place. Also shown is the power supply bracket that you can mount the power supply to before attaching it to the case.
Next Page - Installation
Page 1 - Specifications and Features
Page 2 - Packaging
Page 3 - The Looks
Page 4 - Installation
Page 5 - Final Thoughts