Legit Case Reviews
Cooler Master HAF X Black Gaming Case Review
|Date:||Tue, May 25, 2010 - 11:00 PM|
|Written By:||Shane Higgins -|
Looking to the back of the case we can see the expansion slots have thumbscrews.
Looking under the top bezel we can see the preinstalled 200mm fan and the space for a second. The top of the HAF X is also predrilled to accept up to a 3x120mm radiator for water cooling.
Looking closer we can see the front panel I/O backplane.
The front port cables are more than long enough to reach. The blue cables are the USB3.0 cables that will need to be run though to the back of the case. Cool Master also provides an internal header USB3.0 cable for future use with motherboards that have the USB3.0 internal header.
Here we have the right side of the case. The motherboard tray has a large CPU cut out for allowing access to CPU backing plate without having to completely remove the motherboard. With the bulges in the side panel there is ½” of room between the panel and the motherboard tray for cables to be run.
The space behind the internal 3.5” hard drive bays is plentiful.
The main wire routing hole is large and has well rounded edges. There is no grommet here as it will be covered by the PSU cable management partition.
Pulling one of the hot swap trays we can get a quick look at it. The tray pull looks very similar to that of the front 5.25" bay cover. To pull it out all you have to do is pinch the sides in slightly and pull.
There are mounting points for both 2.5" and 3.5" SATA drives. Drives mount using the bottom mounting points of the hard drive. These drives are not tool-less, but Cooler Master provides mounting screws for both the 3.5" and 2.5" drives.
Next Page - Installing Parts into the HAF X
Page 1 - Cooler Master HAF X
Page 2 - External Impressions
Page 3 - External Impressions Continued
Page 4 - Moving inside the HAF X
Page 5 - Inside Continued
Page 6 - Installing Parts into the HAF X
Page 7 - Installation Continued
Page 8 - FAQ for HAF X
Page 9 - CM HAF X Final Thoughts