Legit Cooling Reviews
Prolimatech PK2 & PK3 Nano Aluminum Thermal Compound Review
|Product:||PK2, PK3 Thermal Interface Material|
|Date:||Mon, Sep 10, 2012 - 12:00 AM|
|Written By:||Raymond Buckland -|
Legit Reviews Testing System
I will be testing the PK2 and Pk3 thermal paste/compounds with my water cooled computer that is currently using the Intel Core i7 3820 CPU. I will not be including the default CPU core speeds for reasons that while using the default CPU core speed of 3.8 GHz the differences between each tested thermal paste/compound did not provide me with enough temperature variation, this variation was roughly about 1°C while using this default CPU core speed of 3.8GHz. So, instead I decided to use a set of strict guidelines that will give me a more reliable temperature variation between each of the tested thermal paste/compounds.
These guide lines will be:
- Each of the thermal paste/compounds will not have a settle in time, the minute the computer booted into Microsoft’s Windows 7, I immediately started my four LinX runs.
- For idle temperatures I allowed the CPU to throttle itself down to 1.4GHz.
- For full load testing results the CPU will maintain an overclock of 4.8GHz.
- Each of the tested thermal paste/compounds will be applied exactly the same way (for this I used a five dot pattern)
- The target average temperature of the CPU will be no more than 75°C, +/- a couple of degrees.
For the testing purposes I will be be running 20 loops on an 64bit version LinX x 4 runs on each of the tested thermal paste/compounds. I will record the highest temperature achieved out of these four LinX runs, on all four cores of the Intel Core i7 3820 CPU, of both idle temperatures and full load temperatures. The program I will be using to monitor the temperature of the CPU will be Core Temp 1.0 RC3. For idle temperatures, I allowed the computer to remain on the desktop for 30minutes after all four of the LinX runs were completed.
Ambient air temperature of the room conducting this review/test remained about 20.5°C, +/- 0.3 °C.
A list of all of the included thermal compounds used in this review:
- Gelid GC-Extreme
- Antec Formula 7 Diamond based compound
- Prolimatech’s PK2 Aluminum based compound
- Prolimatech’s PK3 Aluminum based compound
Since I have explained all of the rules and what I will be including as comparison out of the way, it’s time to see how well the Prolimatech’s PK2 and PK3 performs.
Next Page - PK2 and PK3 Temperature Results
Page 1 - Prolimatech PK2, PK3 TIM
Page 2 - Looking at the PK2, PK3 TIM Up Close
Page 3 - Legit Reviews Testing System
Page 4 - PK2 and PK3 Temperature Results
Page 5 - Final Thoughts on PK2 and PK3 Thermal Pastes